WD Passport holder for Mac Book Air screen.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The hard drive is a WD Passport ultra, the WD Element has the same general dimensions and should fit. So, My mom like…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
The hard drive is a WD Passport ultra, the WD Element has the same general dimensions and should fit.
So, My mom like to use her macbook air on an armchair, and also like to keep stuff on an external hard drive because she only has a super small SSD on that apple computer. But She also keep make the hard drive fall. (There's a backup...)
She mentioned "I would like a thing that holds the hard drive just there" and put it behind the screen.
So, you know, I own a 3D printer... End of story.
Print Settings
Printer:
Dagoma DiscoVery200
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.3mm
Infill:
33%
Notes:
You printer should bridge fine the bottom (top) of the object as it is on the STL file.
Took some digital calipers, take the measurement of the hard drive dimension and the screen thickness. Added a few millimeter as a margins and fired up Fusion 360
Drew the general shape of it laying on the side (Y here is top, your 3D printer top is Z. You can change that on Fusion so it matches, but I'm lazy)
Allways set all the measurements
Extrude this to create a body
Same thing for making the hole
Done.
Category: Computer