Lofi Radio: Pi4 + BrainCraft HAT case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3D printable case for the Raspberry Pi 4 with Adafruit's BrainCraft HAT, designed to complement the Learn system…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 1348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Share Alike
A 3D printable case for the Raspberry Pi 4 with Adafruit's BrainCraft HAT, designed to complement the Learn system project lofi hip hop raspberry pi radio.
This is a remix of Guysoft's Raspberrypi 4 / 4B+ case on Thingiverse, which in turn remixed other designs.
Print instructions
I printed using the 0.20mm Speed settings on an mk3s.
To add color to the inset letters, put a filament change after the 2nd layer of the model and a second filament change 2 layers after the lettering fills in.
Use 4 2.5mm×3.4 mm Installed Length heat set threaded inserts in the base. Secure the BrainCraft HAT with 16mm stand-offs (or 12mm stand-offs plus 2×2mm nuts) on the side opposite the 40-pin connector.
You'll need to flex the wall of the top out a bit to pass it over the part of the jack that protrudes beyond the PCB edge.