1 / 1
1/3 Scale Federal Signal STH-10 (Real Measurements Redone!!!) — zdjęcie 1

1/3 Scale Federal Signal STH-10 (Real Measurements Redone!!!)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

1/3 scale working model of a Federal Signal STH-10 siren!!!! Uses a Samsung DE31-00029H microwave blower motor.

Ocena
5 / 5
Polubienia
51
Pobrania
730
Wydruki
6
Wyświetlenia
4306
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

This is a ⅓ scale working model of a Federal Signal STH-10.  This siren uses a Samsung DE31-00029H microwave blower motor.  It is also compatible with the 29K and 29J and any other 2.9/2.95" length Samsung motor.

Credit to my boi Charlie (Northdakotasirens) for the cover photo.  I haven't finished my personal build yet.

Models come already in their intended print orientation.  

Please print the stator in 99 percent infill.  This will make sure the back of the stator will be decently stiff, so it wont be too easy to make it flex and cause rotor rub.

 

Hardware:

12x M4x10 machine screws (stand assembly)

 For the motor, download it from Demetrius's printables.  Gonna model the Northwestern for this page.  And don't do the retap thing anymore.  I gave original motor screws another chance and its amazing.

12x M4 nuts

 

7x M3x10 machine screws (stator to motor and motor back cap to wire side cover)

10x M3x6 machine screws (joining intake to stator and junction box to motor) 

12x M2x14 machine screws (horn spacers)

24x M2x10 machine screws (mounting horns)

4x M2x6 machine screws (junction box lid)

36x M2 nuts

 

17x M3x5.7mm heat set threaded inserts.

https://www.amazon.com/gp/product/B08BCRZZS3 (I used these)

 

You need two of these capacitors and wire them in parallel for a total of 8uf.

https://www.ebay.com/itm/285415751960

 8mm to 8mm 14mm OD 25mm L shaft coupler 

https://a.co/d/0iklOR8R

1/2" knockout cable clamp connector.  You can get these in store at a hardware store like Ace, Lowes, Home Depot, Menards, etc.  This holds your plug in place on the junction box.

Optional:

https://www.amazon.com/dp/B0DQY69JX4

40x 8x8mm dowels for extra rotor weight.  The windup and winddown are already really nice without these as the rotor weighs about 380 grams.   But these give it about 130 grams of added weight which will give it a decent bit more winddown and make it closer to the real thing.

If you for some reason still want to print the old shitty model, you can download it as a .zip file in the “Other Files” section.  Both the OG OG 2023 model and the later Tinkercad redone model are in the "Other Files" section.

 

 


 

Tagi