Fountain Pen - Jowo #5 unit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fountain pen that uses a Jowo #5 nib unit & Standard International Cartridge/converter
- Ocena
- 4 / 5
- Polubienia
- 22
- Pobrania
- 119
- Wydruki
- 1
- Wyświetlenia
- 980
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fountain pen that uses a Jowo #5 nib unit & Standard International Cartridge/converter. You will have to purchase those separately. I have used an Opus 88 nib unit purchased from Jetpens for this build. I chose to style this one with some vintage elements.
2 body options are given. Option 1 is a longer body that balances well un-posted. Option 2 is a shorter body designed to balance better posted.
The clip is installed with one M2.5 flat head screw 6mm long such as McMaster-Carr part 92010A016
YOU WILL NEED TO PURCHASE A M6.5x0.5 TAP TO FINISH THIS.
Tough PLA works best as regular PLA can be brittle.
Print with a 0.4mm nozzle max. Adaptive layer height down to 0.1mm because there's fine detail on all of the parts. Your printer needs to be well-calibrated to print this accurately
Print all parts with the largest flat face down and use a brim on all except the clip. No support should be necessary.
Print them one at a time for the best result to reduce stringing. You will need to deburr/chamfer the bottom edge with a sharp knife or sandpaper just to ensure a proper fit and removal of the brim.
The whole assembly is approximately 30g and 4 hours of print time.