Fountain Pen - Jowo #5 unit
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fountain pen that uses a Jowo #5 nib unit & Standard International Cartridge/converter
- Rating
- 4 / 5
- Likes
- 22
- Downloads
- 120
- Makes
- 1
- Views
- 982
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fountain pen that uses a Jowo #5 nib unit & Standard International Cartridge/converter. You will have to purchase those separately. I have used an Opus 88 nib unit purchased from Jetpens for this build. I chose to style this one with some vintage elements.
2 body options are given. Option 1 is a longer body that balances well un-posted. Option 2 is a shorter body designed to balance better posted.
The clip is installed with one M2.5 flat head screw 6mm long such as McMaster-Carr part 92010A016
YOU WILL NEED TO PURCHASE A M6.5x0.5 TAP TO FINISH THIS.
Tough PLA works best as regular PLA can be brittle.
Print with a 0.4mm nozzle max. Adaptive layer height down to 0.1mm because there's fine detail on all of the parts. Your printer needs to be well-calibrated to print this accurately
Print all parts with the largest flat face down and use a brim on all except the clip. No support should be necessary.
Print them one at a time for the best result to reduce stringing. You will need to deburr/chamfer the bottom edge with a sharp knife or sandpaper just to ensure a proper fit and removal of the brim.
The whole assembly is approximately 30g and 4 hours of print time.