1 / 20
HEVO Extruder with Dual RJ45 Mount - bltouch or piezo — zdjęcie 1
1 / 20

HEVO Extruder with Dual RJ45 Mount - bltouch or piezo

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of a great extruder mount for the HEVO https://www.thingiverse.com/thing:2617424 and an FT-5 Carriage…

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
161
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a remix of a great extruder mount for the HEVO https://www.thingiverse.com/thing:2617424 and an FT-5 Carriage - RJ45 x 2 round sensor Mount https://www.thingiverse.com/thing:2569068. Remixed the duct Hypercube-Evo fan duct for 70mm Hotend

I like vergienc's Precision Piezo mounts for the HEVO (prefer round mount points for the PP as the oval ones give me nothing but grief). Have been toying with the idea of an 'easily' exchangeable head'. using RJ45 cable

Do NOT connect your hotend heater as the wire is far to thin

Breakout box https://www.amazon.com/Ethernet-Connector-Breakout-Board-terminals/dp/B01BAHLWZ8/ref=sr_1_2?ie=UTF8&qid=1529545677&sr=8-2&keywords=dual+rj45+breakout&dpID=41Cx6pIsPQL&preST=_SX300_QL70_&dpSrc=srch

Finally worked out how to have the board mounted at the back of the extruder, so have abandoned v1.x completely

Extruder is printer with supports, duct is printed without supports

v2.0

Reworked to move the fan from the back of the extruder to the front. That allowed me to move the RJ45 board to the back - which is what I wanted to do originality. The spacer part is in case you need to move the back solder points of the RJ45 board away from the nut/bolt hat holds the fan in place

The duct has some room to lengthen/shorten if your hotend is a different length to mine

Created a bltouch version with different lengths on adapter to accommodate print differences along with bltouch heights

November 1 2018

Remixed a cleaned up version of the BLtouch carriage and mount and a fan/duct. All 3 are what I am currently using on my HEVO. May go to serial or VGA cable ultimately, but htis is good for me now

Tagi