Tree Support Shelf Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tree support is is made to accept a 1x10 plank of wood as the shelving.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 1003
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
This stand is made to accept another stand above it that will hold another 1x4 or 1x6 board.
This is designed to have organic/tree support and the bottom slice is to ensure that it does not drop to the plate, but will not print. I had to play with the overhangs a bit to get the infill of tree branches I wanted. I wanted few where you may want more.
To get it to work you will need to sink the stl so that the bottom layer is under the build plate.
At the moment I lost my settings, but I think I remember they were
17% fill
20 degree branches
This means that the supports would also go around the bottom layer and up to the second. I had to cut them off to accommodate the plank of wood to be inserted.
Updated: 2 and 3 trunk options
Note: all measurements of dimensional lumber are in inches, and will accommodate north American lumber.