1 / 7
Ramps and Arduino Mega enclosure for 3030 v-slot — zdjęcie 1
1 / 7

Ramps and Arduino Mega enclosure for 3030 v-slot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure for Ramps 1.4 and Arduino Mega 2650. Attaches to 3030 V-slot with 5mm bolts and slide nuts, all other…

Ocena
0 / 5
Polubienia
1
Pobrania
20
Wydruki
0
Wyświetlenia
202
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Enclosure for Ramps 1.4 and Arduino Mega 2650. Attaches to 3030 V-slot with 5mm bolts and slide nuts, all other hardware is 3 mm (12 bolts, 9-12 nuts). The variation in the number of nuts is due to variation between printers used. Mounting holes for arduino/ramps are small enough to direct screw into, but if you over tighten and strip the threads you may need to use nuts to retain the ramps/arduino boards.

Cut outs top and bottom for cable entry, at the top for LCD cables and for the USB cable to allow easy updates to firmware.

Lettering for cover can be printed in a second color and then pressed into place for a smoother look.

Cut out for 40mm fan on the cover, but there is also a part included called blower_fan_plate.stl. This allows a blower fan to be used for higher airflow over the stepper drivers.

Print Settings

Printer:

KUSTM3D 250

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.05-0.2

Infill:

10% or higher

Filament:

SUNLU PLA

Black and Green


Notes:

Supports are unneeded on all parts if your printer can bridge without to much sagging. If needed use supports only for blower_fan_plate.stl, set to Everywhere with an overhang angle of 85deg (just less that horizontal) to make removal easier.

Lower layer heights work better with the radius used on the blower\_fan\_plate.

At 0.1mm layer height expect the enclosure to take approx 22 hrs, cover to take 8hrs, blower plate 3hrs and 30mins for small parts and approx 130g of filament

Category: 3D Printer Parts

Tagi