Ramps and Arduino Mega enclosure for 3030 v-slot
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for Ramps 1.4 and Arduino Mega 2650. Attaches to 3030 V-slot with 5mm bolts and slide nuts, all other…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 20
- Makes
- 0
- Views
- 202
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Enclosure for Ramps 1.4 and Arduino Mega 2650. Attaches to 3030 V-slot with 5mm bolts and slide nuts, all other hardware is 3 mm (12 bolts, 9-12 nuts). The variation in the number of nuts is due to variation between printers used. Mounting holes for arduino/ramps are small enough to direct screw into, but if you over tighten and strip the threads you may need to use nuts to retain the ramps/arduino boards.
Cut outs top and bottom for cable entry, at the top for LCD cables and for the USB cable to allow easy updates to firmware.
Lettering for cover can be printed in a second color and then pressed into place for a smoother look.
Cut out for 40mm fan on the cover, but there is also a part included called blower_fan_plate.stl. This allows a blower fan to be used for higher airflow over the stepper drivers.
Print Settings
Printer:
KUSTM3D 250
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.05-0.2
Infill:
10% or higher
Filament:
SUNLU PLABlack and Green
Notes:
Supports are unneeded on all parts if your printer can bridge without to much sagging. If needed use supports only for blower_fan_plate.stl, set to Everywhere with an overhang angle of 85deg (just less that horizontal) to make removal easier.
Lower layer heights work better with the radius used on the blower\_fan\_plate.At 0.1mm layer height expect the enclosure to take approx 22 hrs, cover to take 8hrs, blower plate 3hrs and 30mins for small parts and approx 130g of filament
Category: 3D Printer Parts