Voron 2.4r2 Exhaust Spacer Mod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ensures exhaust housing does not cause rear panel to lean in when Voron 2.4 is built with foam tape on back panel.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 585
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
When I built my Voron 2.4r2 I attached the exhaust housing as per the manual and began printing. About 100 hours in I realised that my back panel had begun to make contact with the rear belts causing minor defects on prints. With closer examination, I realised that this was caused by the back panel leaning in at the exhaust housing because there was no foam tape at this point. Instead of modifying an original part, I designed this spacer to create 3mm of extra space as well as fill any gaps. This works well in my situation for the ABS 3mm back panel.
Print with standard Voron part settings.
Note: this spacer will necessitate using VHB to secure exhaust to the back panel. I've included the STEP file in case you need to modify for your foam tape thickness. My foam is designed for gaps from 2mm-4mm. You may also need to use a longer bolt.