SV06 SUPER Tool Holder

So I made a previous toolbox with extra thingies mounted to it, remixed from one of SavageLau's designs. He made a new design, and I couldn't resist personalizing it. I made what I consider to be improvements:

• Caliper holder on the back (better than the last one!)
• A bit taller (maximum height that can fit under the lip of the gantry)
• Extra slots and spaces in the tray
• Tweaked spaces in the tray for tweezers, wrench, cutters, spatula, allen wrenches, and more so that they are SNUG and stop FLOPPING AROUND (biggest issue I had with the spaces I made into the previous tool tray)

Note that the space for the cutters is designed to include the cap for cutters from this Thingiverse design: https://www.thingiverse.com/thing:5454654/files

Additionally, the caliper holder comes from here: https://www.printables.com/model/272648-caliper-holder

Be aware that the file size is a relatively large 24 megabytes. For some reason it became 19 times larger than what you would expect once I combined the toolbox with the caliper holder. As such, expect a couple hiccups here and there in Cura or modeling programs as it loads in. 

For actually printing this, the caliper holder will require supports and as such you'll need clever use of support blockers. Use them so that only the bottom face of the caliper holder is being supported, and everything else should be blocked off as they should print fine without supports. 

And I am very happy with the result. Again, all credit goes to SavageLau as he's the one who did all the actual work. I'm just a fella who can use TinkerCad and has too much time on their hands. 

The pins are not here and are instead on SavageLau's model so that it gets the attention it deserves and because I am also very lazy. Happy tool-holding!