1 / 4
3d printed rc boat WPL-07 water redirecting spoiler — zdjęcie 1
1 / 4

3d printed rc boat WPL-07 water redirecting spoiler

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a (possibly) upgrade item for thing 3807800 from thingiverse, a printable RC boat

Ocena
0 / 5
Polubienia
8
Pobrania
16
Wydruki
0
Wyświetlenia
661
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution

This is a (possibly) upgrade item for thing 3807800 from thingiverse, a printable RC boat. If your engine/shaft/propeller setup is different you might not have the same use of it. In my case though, when going backwards, the propeller pushes water hard enough for it to go over the back of the boat and inside of the boat. This at least limits if not prevents it fully, by redirecting it backwards on a ramp

V1 is smaller (white in picture), better looking, but still allows some water to be thrown on top of the steering servo

V2 is bigger (green in picture), wider and has lips that stop the upwards water flow better

Tagi