Sovol SV06 and Plus Dial indicator mount

I had to test a few spots across my hotbed so I made a simple model to attach a dial indicator after taking off the extruder. Nice and simple print, depending on your settings it's 30-40 minutes. I used PETG (probably PLA will be fine too) with 0.3 layer height, 25% infill, and added just two tiny supports into M5 holes so they were nice and round, overall it's strong enough, won't bend or crack when playing with it.

Parts required:

• dial indicator, I used some Amazon one, but most of them will have pretty much the same dimensions https://www.amazon.co.uk/dp/B08PCVP2SZ
• M5*6*7 heated thread insert
• M5 bolt of any type you prefer with at least 16mm of thread length.

Hole on one side is bigger so you can use a heated thread there, if you don't have one, you can just put a nut at the end of the longer thread. Gap between these ‘fins’ should be tight fit, but it also requires some tightening of the bolt, so the dial indicator won't swivel when using it.
To attach it - simply carefully unplug your ribbon plug from the extruder, then undo 3 hex screws holding the extruder to the carriage. You can reuse them to attach this mount, there's no need for anything else. After testing your bed just revert everything. 

Caution!

• I STRONGLY recommend unplugging your X and Y motor wires when using it so there won't be any voltage generated by motors going back to your motherboard! 
• You might need to SLIGHTLY readjust your Z offset afterwards and realign your X axis, screws holding the extruder are countersunk so it shouldn't move a lot, but there might be a tiny difference.

Enjoy.