1 / 2
1" Ball clamp for telescope trusses - clearance remix — zdjęcie 1
1 / 2

1" Ball clamp for telescope trusses - clearance remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of Sasha's ball clamps to better fit hardware. Clearance holes etc.

Ocena
0 / 5
Polubienia
9
Pobrania
46
Wydruki
1
Wyświetlenia
618
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

See the original for details, but use a 60mm hex-head bolt for the clamps.  A future remix will likely switch the direction of the thru-bolt.

Make sure to print it sturdy.  I used 6 walls and 30 or 50% cubic infill.  (Do note that increasing walls is better for sturdiness than increasing infill, and beyond 50% infill returns are not significant)



Works well enough for a 16 inch reflector, and even PETG-on-metal provided a good enough grip to loosen nyloc bolts for Hexapod collimation.  If this jargon means nothing to you, do one of:

  • read up; this is only mildly complicated, but the info is scattered through old forum posts and word-of-mouth
  • find me on discord
  • find a place where I have put more documentation.
  • re-think making such a complicated telescope.

I'm hosting the files for my 16-incher for anyone to follow in my footsteps, but these are just provided as-is.