Picoprobe (debug probe) - RP2040-Zero case v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An enclosure for RP2040-Zero board running Picoprobe firmware
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 298
- Wydruki
- 5
- Wyświetlenia
- 2225
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A dedicated case for the smallest usable RP2040 board I could find. It has labels for pins used by Picoprobe and a separate hole for each cable to prevent tangling. It screws together with (up to) 4 M3 14mm screws (and nuts).
The project was designed for Bambu AMS multi-color print but the labels should stay legible if they are not filled with color (recessed only).
It prints nicely with a textured plate and supports on both sides.
In this version, I added mini-clips holding the cables in place to help with putting the thing together.
Related links
https://github.com/raspberrypi/picoprobe
https://www.waveshare.com/wiki/RP2040-Zero
https://datasheets.raspberrypi.com/pico/getting-started-with-pico.pdf
Wiring
You can follow the official “Getting started…” guide linked above. The needed GP2, GP3, GP4, GP5 are marked as 2,3,4,5 on the RP2040-Zero board.
