OralB grip cover | OralB Griffüberzug
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cover for the handle rubber in dissolution | Ein Überzug für das sich in Auflösung befindliche Griffgummi
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 280
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
english (german below)
Unfortunately, the rubber on the handle of my electric toothbrush is disintegrating.
I have printed a cover that will let me use the brush longer.
Material: Filaflex Red 82A
Printed in vase mode with border.
Please leave the edge on; it serves as a help to put on the cover (from the brush side). This can be a bit difficult as it does not slip over the rubber. Then push it on with your fingers and pull on the edge with pliers if necessary.
When the cover is in position, it is best to clip off the edge with an electronic side cutter.
______________________________________________________________________________________________________________
deutsch
Bei meiner elektrischen Zahnbürste löst sich leider der Gummi der Griffschale auf.
Ich habe mir einen Überzug gedruckt, der mich die Bürste länger nutzen lässt.
Material: Filaflex Red 82A
Gedruckt im Vasenmodus mit Rand.
Den Rand bitte dranlassen; er dient als Hilfe zum Aufziehen des Überzugs (von der Bürstenseite her). Das kann etwas schwer gehen, da es über dem Gummi nicht rutscht. Dann mit den Fingern nachschieben und evtl. mit einer Zange am Rand ziehen.
Wenn der Überzug in Position ist, am Besten mit einem Elektronik-Seitenschneider den Rand abknipsen.