Breadboard Voltmeter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for those mini voltmeters.
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 114
- Wydruki
- 0
- Wyświetlenia
- 630
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This enclosure for those common cheap mini voltmeters lets you clip them into the power rail of your breadboard.
Step 1: Solder two wires to the board (combine red+yellow to a single wire, this way you don't need a separate power line, downside is you won't be able to measure anything below 4V)
Step 2: Solder those wires to a pin header.
Step 3: Place the voltmeter in the enclosure bottom. (Omg, what a mediocre solder job. Good that nobody will see it once it's enclosed.)
Step 4: Put the enclosure top on and push the mounting clips into their holes until they snap in with a satisfying click sound.
If it's too loose/tight, you can scale the clips in your slicer.
Done :)
