Breadboard Voltmeter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure for those mini voltmeters.
- Rating
- 0 / 5
- Likes
- 22
- Downloads
- 114
- Makes
- 0
- Views
- 630
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
This enclosure for those common cheap mini voltmeters lets you clip them into the power rail of your breadboard.
Step 1: Solder two wires to the board (combine red+yellow to a single wire, this way you don't need a separate power line, downside is you won't be able to measure anything below 4V)
Step 2: Solder those wires to a pin header.
Step 3: Place the voltmeter in the enclosure bottom. (Omg, what a mediocre solder job. Good that nobody will see it once it's enclosed.)
Step 4: Put the enclosure top on and push the mounting clips into their holes until they snap in with a satisfying click sound.
If it's too loose/tight, you can scale the clips in your slicer.
Done :)
