Lens cap 34mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spring-loaded lens cap for my Industar 50-2 50mm f/3.5 camera lens. It should work fine with all ⌀34mm lenses.
- Ocena
- 4,5 / 5
- Polubienia
- 20
- Pobrania
- 142
- Wydruki
- 2
- Wyświetlenia
- 888
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
Spring-loaded lens cap for my Industar 50-2 50mm f/3.5 camera lens. It should work fine with all ⌀34mm lenses.
Print instructions
I made this one as I prefer a spring-loaded inner cap, if you prefer an outer one, go for https://www.thingiverse.com/thing:2133519.
Notes
The thing was designed with ABS flexibility in mind. PLA might be too rigid for this design (ie. "springs" might require uncomfortable amount of force to operate).
Post-Printing
After printing, one needs to:
- glue the middle of the springs to the main body (the red to the blue part),
- glue the inner walls to the body (the yellow parts into the blue one).
If one's printing the thing of ABS, then a single drop of acetone suffices as an adhesive (or rather solvent).