Minisforum UM690 120mm fan custom case

To assembly,

1. pass the first wireless antena trough its holders on the back panel
2. slide the back panel into the bottom
3. install the board into the 4 holders (to avoid damage try to arch the panel instead of pushing the pilars)
4. slide the top panel into the back panel
5. slide the right panel into the bottom and top at about the same time
6. pass the second wireless antena trough the holders on the front panel (picture)
7. slide the front panel into the bottom and top at about the same time
8. install the fan (picture before fan)
9. slide the left panel into the bottom and top at about the same time, its locking pins may need a little help to pass trough

first 4 steps can be mixed a bit.

-the slide must be done completely, that means that one panel side should face the outside face of the previous panel
-still, try not to force the little fastening bits
-use electric tape to insulate exposed metal parts of the wireless antenas
-all the supports are in model, only corner brims are needed
-little fastenings supports need to be cut with the sidecutter after print (picture attached)
-also supports from board holders need to be removed with a thin tool (needle, thin screwdriver etc.) (picture attached)
-there is also a frames only version if you want to make a test print, it uses much less material, it can also be used to calibrate the flow for fiting (try rightf with topf, it should fit pretty easy)
-the one in the image is printed in ABS, i recommend ABS but other materials may work too
-fan connector pinout: fan(standard): 1 2 3 4 / black red white blue | board: 3 1 4 2 / white black blue red (picture attached)
-i used a connector scrapped from a laptop fan to make the adapter, it does not fit perfectly
-designed with 0.2mm layer height in mind

cpuz stress test: cpu 78C, ram 45C (64gb), ssd 43C, fan 1060rpm, room 26C

um690-moding discord: https://discord.gg/fC2c5dXemK