Suzuki Vitara (2015-) Cupholder Trash Can
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D model of a trash can made specifically for Suzuki Vitara 2015 onwards models.
- Ocena
- 4,667 / 5
- Polubienia
- 51
- Pobrania
- 295
- Wydruki
- 4
- Wyświetlenia
- 1534
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a 3D model of a trash can made specifically for Suzuki Vitara 2015 onwards models. It perfectly fits into any of the two existing cupholders in the centre console. It has a hinge that connects with a piece of 1,75mm standard filament, and it has a snap mechanism so it doesn't rattle while the engine is running.
The height is 15cm, you can put a lot of small pieces of trash you would usually collect in various places in your Vitara, when it fills up you can just take it out and empty the trash. Helps you keep your car nice and tidy.
It's made and tested specifically for Vitara, but I believe it should fit Suzuki SX-4 cross as well. (not tested)
--- UPDATE ---
Added a new version of the lid that has notches on the side so it stops it from moving side-to-side when the lid is closed.
--- INSTRUCTIONS ---
Print in PLA/PETG
Total wall thickness is 1mm
No supports needed
Connect the hinge with a piece of 1,75mm filament
Just take a piece of filament, align the holes of the hinge and push the filament through the holes. Cut the excess filament on the sides.