1 / 3
Salt / Sugar Dispenser Lid
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lid to store and pour salt/sugar
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 342
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
My second take on the lid contest.
I quite love this one, simplistic yet very effective.
Version A:
has a slot on the lid to cover the gap
Version B:
Has the notch covering the gap
My Print (pictures) does have a few spaces, but that is due to high humidity. I hope to get my hands on a filament dehydration machine.
For best results, this has to be printed,
- upside down.
- supports enabled with interface layer (I used 60%).
- support Z distance, this will vary on ur printer, I use 0.2 for easy support removal and for a good finish.
- X/Y distance 0.8mm (or even higher) to be able to remove the support easier. This could potentially be printed with bridging, but in my opinion, the sliding part would weld to the previous layer.
- I printed with 0.2mm layer height. If you choose a different height, after slicing, make sure there is a free layer between the notch and the lid.