Gridfinity Solder, Flux, and Tool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is intended to hold a Kester 1lb roll of solder along with a flux pen, and has holes for additional tools.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 76
- Wydruki
- 1
- Wyświetlenia
- 781
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 2x2 Gridfinity organizer for some of my soldering materials. I use Kester 1lb rolls of solder, which are about 60mm diameter. I found dedicated solder holders are not space efficient, so I wanted a combo organizer. I also like to use a flux pen, which is about 14mm diameter. I made a 16mm hole for the flux. I also made additional holes for small tools, like tweezers. I use this along with other organizers on a 4x4 plate for cutters, water, solder sucker, wick, etc.
I used a ½" dowel rather than print a post.
I used Gridfinity Rebuilt just to generate the base plate and cube. I have yet to fully dig into this openscad project enough to fully understand it. It was useful to get started.