Gridfinity Solder, Flux, and Tool Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is intended to hold a Kester 1lb roll of solder along with a flux pen, and has holes for additional tools.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 76
- Makes
- 1
- Views
- 787
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 2x2 Gridfinity organizer for some of my soldering materials. I use Kester 1lb rolls of solder, which are about 60mm diameter. I found dedicated solder holders are not space efficient, so I wanted a combo organizer. I also like to use a flux pen, which is about 14mm diameter. I made a 16mm hole for the flux. I also made additional holes for small tools, like tweezers. I use this along with other organizers on a 4x4 plate for cutters, water, solder sucker, wick, etc.
I used a ½" dowel rather than print a post.
I used Gridfinity Rebuilt just to generate the base plate and cube. I have yet to fully dig into this openscad project enough to fully understand it. It was useful to get started.