1 / 9
AnkerMake M5 build plate bracket
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
printable AM5 build plate bracket
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 953
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (32)Powiązane
This is printable AM5 build plate bracket derived from original metal frame bracket. It allows to cut ~120g of printer bed mass.
Recommended printer settings:
- perimeters: 5, at least 4
- infill: gyroid 20-40%, depending on expected mass savings
- supports should not be needed but check holes bridges after slicing. You might want to enforce supports there
- filament: ABS or ASA for “mount” pucks as these need to be temperature resistant, for the bracket itself you want filament with highest possible flexural modulus (>4000MPa), like PLA-CF, PLA-GF, ASA
To mount it you'll also need 20mm m4 screws with countersunk head and nuts.
After printing please check dimensions as pictured on the last screenshot. You should not exceed +-0.15mm tolerances for linear dimensions and holes should be spot on.
This is still beta. It works but I’m not fully happy with result. I wanted to save more mass and it turned out not that easy with needed rigidity of the bracket.