MicroSD & SD Adapter Card Wallet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Loved the wallet made by aerobatflyer on thingiverse, but needed it to hold my SD adapter as well.
- Ocena
- 4,5 / 5
- Polubienia
- 61
- Pobrania
- 387
- Wydruki
- 3
- Wyświetlenia
- 2763
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Loved the wallet made by aerobatflyer on thingiverse, but needed it to hold my SD adapter as well. Second ever model, so I'm lowkey proud of the modifications I made. Ask me if you want some other configuration and maybe I'll make it.
Modifications:
-Added full size SD tray.
-Deepened the MicroSD trays, as there was more room due to the thicker SD slot.
-Made the MicroSD Cards fit more snugly by bringing the notch further down by 0.9mm.
Print instructions
Printer:
Monoprice MP10
Supports:
No
Infill:
100%
Filament: Tecbears PLA Black
Notes:
</p>
Should be obvious how to orient these, but I printed the slider flat, and the case open-side-up. 100% fill because there was basically no difference in time due to the thinness, and they're such fragile parts anyways.
Post-Printing:
Run the top of the tray over sandpaper a few times to smooth it off checking fit as you go until snug. Shouldn't have any problem with it falling out if you do it properly.