swimming FlexiFish stand with magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A flexible fish that prints in 1 hour. Can swim. Can be used as a stand. With magnet support.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 149
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Share Alike
This FlexiFish is a great flexible fish. It can swim, can be used as a stand (ex. for a Rubik's cube) and can interact with magnets.
Printing and assembly:
You can print it with PLA. It even works with 2 perimeters and 0 infill. Use 0.2mm layer height. You need good bed leveling. Good bed adhesion is not recommended. After it's done, remove from the bed carefully. If you are using a scraper, do it from the side, not front/back or you'll break it. If you want it to be attracted to magnets, add M3 x theshortestyouhave screws to the holes. You can magnetize the screws or use it with a small magnet. If you don't add the screws, you'll have to use rope to hold it in the stand position.