1 / 3
Flsun SR - Mount for Orbiter v2.0 and 5015 fans (NEW VERSION AVAILABLE ON MY PROFILE) — zdjęcie 1
1 / 3

Flsun SR - Mount for Orbiter v2.0 and 5015 fans (NEW VERSION AVAILABLE ON MY PROFILE)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for the Orbiter v2.0 extruder by LDO Motors, and 5015 radial fans for improved

Ocena
0 / 5
Polubienia
22
Pobrania
193
Wydruki
0
Wyświetlenia
1338
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

(NEW VERSION AVAILABLE)

 

 

Mount for the Orbiter v2.0 by LDO, easy to print with support material, great for upgrading your Flsun SuperRacer to direct drive.

M3 Heat-set inserts are required for the extruder mount, heatsink fan and for the effector. For the radial fans I chose to use printed pins, as the fans clip in place, and the stopper on the top is there only to prevent the fan coming loose. 

For both the mount and pins that secure the fans, PLA works fine. 

Supports: I printed the model with supports only for the bridge section, and the circular mounts for the extruder. The holes on the bottom, the ones for the front axial fan and the ones for the radial fans are printed without supports, i suggest to use a 4mm drill bit to round them after the print, in order to facilitate the insertion of the heat-set inserts.

The seats of the pins that secure the radial fans are very fragile. This is by design, to reduce weight, that part is not subjected to heavy mechanical stress, as the fan is stuck in its seat, so be careful when handling the finished piece. (yeah i dropped one and it broke :(  )

Cable management: I used some of the original fabric that covered the cables, and used a piece of the old bowden tube as a strain-relief. The extruder cable needs to be ran to the motherboard, and plugged where the old extruder cable was. For the filament sensor i found a mount online, but the original metal mount works fine also.

On the firmware side, the documentation given with the Orbiter extruder has all the instructions. The gcode provided needs to be sent to the printer from a laptop using pronterface. 

 

I also suggest 0.1mm layer height.

 

 

Tagi