Parkside PWM A1 Anemometer tripod adapter and holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The anemometer has no surface to stand on, so I designed a holder to put it in. it can also be mounted on a tripod.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 624
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The anemometer has no surface to stand on, so I designed a holder to put it in. it can also be mounted on a tripod, if you get one of those adapter screws( amazon link ) and put it in from the inside. I used a heatgun to soften the plastic before screwing it in.
To fix the bar you'll need two countersunk m3x10mm screws.
The fit was a bit on the thight side, maybe do a partial test print and see if you have to adapt horizontal expansion or flow values.
If you want to support my work, consider leaving a tip or a friendly comment here on Printables. :)
Category: Tool Holders & Boxes