1 / 2
Bracelet/Necklace — zdjęcie 1
1 / 2

Bracelet/Necklace

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Show that you own a 3D printer!

Ocena
0 / 5
Polubienia
55
Pobrania
182
Wydruki
1
Wyświetlenia
1045
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This was quite a lot of fun to make!

This should be printed at slow speeds. 
To save filament, print the test print first to make sure the layers do not stick. There is only one layer gap with minimal contact area. If it does stick, use an exacto knife and slightly nudge the connections it should let go with minimal force.

To print:

Slow Speed: 30mm/s - this will vary depending on the machine, but watch for edge warping

Layer Height: 0.2mm

Plate Adhesion: Brim - 2mm+

 

My initial design was with magnets. Maybe I am too obsessed with magnets lol.

Instead of the clip, it can be a pin to hold a different 3d print!

 

Tagi