Bracelet/Necklace
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Show that you own a 3D printer!
- Rating
- 0 / 5
- Likes
- 55
- Downloads
- 182
- Makes
- 1
- Views
- 1,045
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution
This was quite a lot of fun to make!
This should be printed at slow speeds.
To save filament, print the test print first to make sure the layers do not stick. There is only one layer gap with minimal contact area. If it does stick, use an exacto knife and slightly nudge the connections it should let go with minimal force.
To print:
Slow Speed: 30mm/s - this will vary depending on the machine, but watch for edge warping
Layer Height: 0.2mm
Plate Adhesion: Brim - 2mm+
My initial design was with magnets. Maybe I am too obsessed with magnets lol.
Instead of the clip, it can be a pin to hold a different 3d print!