1 / 3
30% Size Cam Clip Using 1.75mm Filament Pieces as Hinge EXPERIMENTAL — zdjęcie 1
1 / 3

30% Size Cam Clip Using 1.75mm Filament Pieces as Hinge EXPERIMENTAL

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Trying to print the excellent Bag Cam Clip by Andrei at smaller sizes fails for me at the hinge pins.

Ocena
0 / 5
Polubienia
4
Pobrania
43
Wydruki
0
Wyświetlenia
842
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Trying to print the excellent Bag Cam Clip by Andrei at smaller sizes fails for me at the hinge pins. I had the idea to use a small bit of filament instead, so added ~2mm holes.
It's a pretty strong little clip even at this size and is only about a gram of plastic!

Print instructions

Use the .3mf if you can, support blockers and settings are already in place.
Otherwise, you'll need support on build plate only and a 0.15mm layer height with decent infill %.
Work a piece of 1.75mm filament - you probably have short pieces laying around you can use - through each of the two holes, and then melt the ends to make a sort of plastic rivet.
I used the tip of a 3d pen but a soldering iron would work too.

Tagi