1 / 3
30% Size Cam Clip Using 1.75mm Filament Pieces as Hinge EXPERIMENTAL — image 1
1 / 3

30% Size Cam Clip Using 1.75mm Filament Pieces as Hinge EXPERIMENTAL

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Trying to print the excellent Bag Cam Clip by Andrei at smaller sizes fails for me at the hinge pins.

Rating
0 / 5
Likes
4
Downloads
43
Makes
0
Views
847
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

Trying to print the excellent Bag Cam Clip by Andrei at smaller sizes fails for me at the hinge pins. I had the idea to use a small bit of filament instead, so added ~2mm holes.
It's a pretty strong little clip even at this size and is only about a gram of plastic!

Print instructions

Use the .3mf if you can, support blockers and settings are already in place.
Otherwise, you'll need support on build plate only and a 0.15mm layer height with decent infill %.
Work a piece of 1.75mm filament - you probably have short pieces laying around you can use - through each of the two holes, and then melt the ends to make a sort of plastic rivet.
I used the tip of a 3d pen but a soldering iron would work too.

Tags