EcoGrip 3 - Slackline webbing grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Topology optimized slackline linegrip! Strong and lightweight, low cost!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 87
- Wydruki
- 1
- Wyświetlenia
- 571
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a follow-up project to a previous 3D printed Line grip project. This has been break tested at over 6kN in PLA (minor modification since that test should increase this) - more tests to come. PETG will be even stronger!
This was created using mechanical analysis software and topology optimization to create an extremely light and robust product, weighing in at <80g, this is about the same weight as the Petram Cito, with a lot more surface area - so less chance of damaging your webbing. (And a fraction the cost)
3mm Vibram XS Grip2 rubber for the plate, well prepared and super-glued to the base.
Spliced 3mm Dyneema for the rope, but it will accept up to 6mm cord.