1 / 4
"Standby Stand" Remix for Apple MagSafe iPhone
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This version of the "Standby Stand" addresses several issues with a genuine MagSafe charger.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 191
- Wydruki
- 9
- Wyświetlenia
- 1126
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 9) (Komentarze: 9)Remiksy (0)Kolekcje (26)Powiązane
While I like the original design for the "Standby Stand" there were several problems using it with a guenuine MagSafe charger. This model hopes to address them as follows.
- I reduced the size of the circular top part, it is now a snug fit with a genuine MagSafe charger (the original was very loose and some people were glueing it in).
- I added a push hole in back to easily remove the charger without having to pull on the cable.
- I increased the height and width of the passthrough hole in the stalk because the genuine charges USB-C plug could not fit through the original hole.
- I increased the diameter of the stalk by 2mm to accommodate the larger passthrough whole.
- I remerged the stand as one piece so that it is not necessary to glue the two pieces together after printing. This does require the use of supports, but if you use tree supports on “build plate only” it does not cause issues with the surface finish and the print time is not significantly higher. Picture is included to show the tree supports.