2023 Ford Expedition Enhanced Multi-drink Holder

The model by KJames was a good baseline but it didn't fit snuggly on my vehicle allowing a lot of front to back wobble. With the leverage of a big bottle in it, that becomes a problem. It also didn't fit my Thermalflask bottles with the silicon sock on and I didn't want to have to remove it each time. I very nearly rebuilt the whole model to adjust so I added a lot of features along the way.

I updated it for a very snug fit with absolutely no movement in the 2023 Ford Expedition  Timberline though all 4th gens should fit. It now fits Hydroflask, Thermalflask with silicon sock, coffee mug, 12oz soda can and 8.4oz Redbull. There are multiple rings on the inside to create a catch shelf for each drink type for a snug fit while placing it at optimal height for easy grab and no wobble. It also holds fast food and coffee drink (Starbucks) cups securely as well. I wanted a one for all approach which didn't require ever removing the cup holder extender and so far this has been perfect. 

I printed in black eSUN ABS which comes out matte and matches the black leather interior of my Timberline model very nicely.

25% infill and 4 walls should be ok. Use the higher of the two if using a filament more susceptible to heat warp. The model is very sturdy in ABS though at the lower range.

On my Bambu I used hybrid tree supports which was likely overkill. The registration tab on the bottom should get some support but above that it should print fine without supports as I minimized the overhangs. Technically with the firm fit of this model, the registration tab shouldn't be needed but I kept it from the original model and just refined it a bit. Print upright as you would use it. I made the base wide enough to not require a brim as well.