12oz Can Dispenser slim top
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the wonderful "12oz Can Dispenser" by Lopatka. Cut the top off, saves a bit of plastic and print time.
- Ocena
- 5 / 5
- Polubienia
- 61
- Pobrania
- 488
- Wydruki
- 5
- Wyświetlenia
- 2139
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
A remix of the wonderful "12oz Can Dispenser" by Lopatka.
Cut the top off, saves a bit of plastic and print time. Was forced to cut a bit off the top so it would fit my fridge. Would otherwise have chosen the original design for it's sleek look.
Fits US cans. UK cans fit too but not as snuggly. Edges are high enough so the cans doen't fall off.
Print instructions
Same as original unit:
DO NOT CHANGE THE ORIENTATION. Use 2 parameters, at least 5 top and bottom layers, 0.2 layer height, and an infill of 10% is recommended. No supports are needed. PLA or PETG are recommended. Since this is a large print you will need to make sure your print surface is clean and you have a good first layer.