12oz Can Dispenser slim top
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of the wonderful "12oz Can Dispenser" by Lopatka. Cut the top off, saves a bit of plastic and print time.
- Rating
- 5 / 5
- Likes
- 61
- Downloads
- 488
- Makes
- 5
- Views
- 2,139
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
A remix of the wonderful "12oz Can Dispenser" by Lopatka.
Cut the top off, saves a bit of plastic and print time. Was forced to cut a bit off the top so it would fit my fridge. Would otherwise have chosen the original design for it's sleek look.
Fits US cans. UK cans fit too but not as snuggly. Edges are high enough so the cans doen't fall off.
Print instructions
Same as original unit:
DO NOT CHANGE THE ORIENTATION. Use 2 parameters, at least 5 top and bottom layers, 0.2 layer height, and an infill of 10% is recommended. No supports are needed. PLA or PETG are recommended. Since this is a large print you will need to make sure your print surface is clean and you have a good first layer.