M6x75mm bolt for Miniature Vice 2.0
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Took the Miniature Vice 2.0 75mm bolt and added M6 nut instead of shifted rectangle at the end
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 129
- Wydruki
- 0
- Wyświetlenia
- 438
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
About:
So I printed Miniature Vise 2.0 (much easier to assemble and 100% printable) and noticed I do not have a bolt for it.
Yet the Miniature Vice 2.0 => 100% printed, no metal parts required contains the bolt but it has different head (shifted rectangle) and thus different knob, and I just did not want to print the knob again.
I combined the bolt with M6 nut and that's all.
Please give a like and post makes and provide comments for further improvements.
Print:
Set 100% infill, print vertically if possible.
Photos from PETG 0.20mm
Post-Processing:
Depending on the print quality you may need to use a bit fo sand paper to trim the sides of the bold so it fits the knob.