GepRC Mark5 ELRS Antenna Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
When I couldn't find a fitting ELRS antenna holder for the Gep Mark5, I designed one. To ensure screw-tightening force.
- Ocena
- 0 / 5
- Polubienia
- 40
- Pobrania
- 818
- Wydruki
- 0
- Wyświetlenia
- 2178
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- GNU General Public License v2.0
I was unable to find a suitable model for an ELRS antenna holder that fits the GepRC Mark5, so I made my own.
Additionally, I designed a version that allows for spacers, made of a more robust material like polycarbonate (PLA would probably also work equally well). This setup ensures that the majority of the force from the tightened screws is transferred into the drone's carbon fibre plate and aluminum stand-offs, rather than compressing the TPU excessively. I've always been wary of the way traditional setups necessitate the squishing of TPU to generate enough force to properly secure the screws to the frame.
The spacers are approximately 0.2mm shorter than the TPU printed parts, so the TPU only bears a minimal amount of force. Most of it is effectively channeled into the spacers and the frame, improving both stability and longevity. It is a good idea to add some washers to the bottom screws, I used some aluminum M3 washers for my build.