Victorinox Cybertool Bit Locker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use standard 4mm hex bits without them falling out and more securely hold the stock bits.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 1421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
After losing a bit I tried a standard 4mm one without a detent ball, only to see it immediately fall out. But the ones with the ball are fairly loose anyway so I didn't want to buy more.
Made this stronger holder which doesn't block the other tools. And works with the stock bits.
- Insert bit in cybertool,
- slip bit holder hole over bit,
- snap to the cybertool arm.
0.2 layer height, print on its side to gain strength from layer orientation, with a small bit of support on the open end. recommend a stronger material like pla± as it's a very small part. Normal pla is probably too brittle.
V2. Slimmer and stronger design now that its printed on its side.