Victorinox Cybertool Bit Locker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Use standard 4mm hex bits without them falling out and more securely hold the stock bits.
- Rating
- 0 / 5
- Likes
- 20
- Downloads
- 92
- Makes
- 0
- Views
- 1,421
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
After losing a bit I tried a standard 4mm one without a detent ball, only to see it immediately fall out. But the ones with the ball are fairly loose anyway so I didn't want to buy more.
Made this stronger holder which doesn't block the other tools. And works with the stock bits.
- Insert bit in cybertool,
- slip bit holder hole over bit,
- snap to the cybertool arm.
0.2 layer height, print on its side to gain strength from layer orientation, with a small bit of support on the open end. recommend a stronger material like pla± as it's a very small part. Normal pla is probably too brittle.
V2. Slimmer and stronger design now that its printed on its side.