1 / 7
PTFE Filament Conduit for LACK and PLATSA Enclosure — zdjęcie 1
1 / 7

PTFE Filament Conduit for LACK and PLATSA Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For v1 and v2 LACK and PLATSA enclosures, to feed filament from the top without the excruciating scratching noise.

Ocena
4,889 / 5
Polubienia
111
Pobrania
447
Wydruki
9
Wyświetlenia
4344
Oceny
9

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Most filament guides I found were just plastic conduits through the lid, and in my experience the filament scratching across the plastic gets amplified like crazy by the enclosure.

So I came up with this idea of running a PTFE tube through a conduit. It requires a PC4-M10 or PC4-M8 pneumatic fitting to ensure the PTFE stays in place. This way it is easy to remove the tube when you need to take the printer out of the enclosure. I use it with both, Minis and Mk3S/Mk4 printers.

UPDATE 06-28-2025: On popular demand 🙂, I've added a version for PLATSA enclosures, with a lid depth of 22mm.

Three versions:

  • unmodified LACK lid
  • LACK with the cutout for the MMU
  • PLATSA lid
Print instructions

I printed it in Prusament PETG, 0.2 mm layer height, 15% infill, no supports. 

To install, drill a 0.5 inch hole into the lid of the LACK enclosure. Screw a PC4-M10 fitting (e.g., https://amazon.com/gp/product/B01IB81IHG/) or PC4-M8 fitting into the bottom-part. Insert it from below into the hole you just drilled and secure it from above with the top-part.

For the Mini, replace the PTFE tube to the extruder or the short stub at the filament sensor with a long piece of PFTE and push it from below through the fitting and cut to size. For the MK3S/Mk4 I just use a small piece of PTFE, maybe four, five inches long.

To remove the tube, just push down on the black collet and pull the tube out.

Version history

UPDATE 12-18-2022: While the PC4-M10 push-through version works fine for me, on the Mini I sometimes ended up a with slipping PTFE tube so I added a PC4-M8 version (not push-through. I put the conduit in with the PC4 fitting on the inside of the enclosure and connect it to the PTFE tube leading to the extruder/filament sensor, then put a short 3 or 4 inch piece of PTFE tube in the other end of the conduit, outside of the enclosure.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.

Tagi