1 / 7
PTFE Filament Conduit for LACK and PLATSA Enclosure — image 1
1 / 7

PTFE Filament Conduit for LACK and PLATSA Enclosure

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

For v1 and v2 LACK and PLATSA enclosures, to feed filament from the top without the excruciating scratching noise.

Rating
4.889 / 5
Likes
111
Downloads
447
Makes
9
Views
4,344
Reviews
9

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

Most filament guides I found were just plastic conduits through the lid, and in my experience the filament scratching across the plastic gets amplified like crazy by the enclosure.

So I came up with this idea of running a PTFE tube through a conduit. It requires a PC4-M10 or PC4-M8 pneumatic fitting to ensure the PTFE stays in place. This way it is easy to remove the tube when you need to take the printer out of the enclosure. I use it with both, Minis and Mk3S/Mk4 printers.

UPDATE 06-28-2025: On popular demand 🙂, I've added a version for PLATSA enclosures, with a lid depth of 22mm.

Three versions:

  • unmodified LACK lid
  • LACK with the cutout for the MMU
  • PLATSA lid
Print instructions

I printed it in Prusament PETG, 0.2 mm layer height, 15% infill, no supports. 

To install, drill a 0.5 inch hole into the lid of the LACK enclosure. Screw a PC4-M10 fitting (e.g., https://amazon.com/gp/product/B01IB81IHG/) or PC4-M8 fitting into the bottom-part. Insert it from below into the hole you just drilled and secure it from above with the top-part.

For the Mini, replace the PTFE tube to the extruder or the short stub at the filament sensor with a long piece of PFTE and push it from below through the fitting and cut to size. For the MK3S/Mk4 I just use a small piece of PTFE, maybe four, five inches long.

To remove the tube, just push down on the black collet and pull the tube out.

Version history

UPDATE 12-18-2022: While the PC4-M10 push-through version works fine for me, on the Mini I sometimes ended up a with slipping PTFE tube so I added a PC4-M8 version (not push-through. I put the conduit in with the PC4 fitting on the inside of the enclosure and connect it to the PTFE tube leading to the extruder/filament sensor, then put a short 3 or 4 inch piece of PTFE tube in the other end of the conduit, outside of the enclosure.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.

Tags