1 / 4
Tag Connect Retaining Clip for 6 pin and 10 pin debug probes — zdjęcie 1
1 / 4

Tag Connect Retaining Clip for 6 pin and 10 pin debug probes

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a 3d printed retaining clip for tag connect debug probe.

Ocena
5 / 5
Polubienia
8
Pobrania
256
Wydruki
1
Wyświetlenia
1318
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution

This is a 3d printed retaining clip for tag connect debug probe.

This is because the clip provided by tag connect is expensive.

Dimensions is based on http://www.tag-connect.com/Materials/TC2030-IDC.pdf

This openscad design used my previous protective cap for tag-connect in https://www.thingiverse.com/thing:3025584 as the base. But without the loop and with tighter tolerance for the alignment clip, so it can friction hold the alignment pin.

This is a work in progress, I will print this out soon to confirm if it works well as a retaining clip.

V1 :- Works well with PETG filament. PLA is a bit too soft.

Print instructions

Unassociated tags: debug probe

Category: Tools Summary

This is a 3d printed retaining clip for tag connect debug probe.

This is because the clip provided by tag connect is expensive.

Dimensions is based on http://www.tag-connect.com/Materials/TC2030-IDC.pdf

This openscad design used my previous protective cap for tag-connect in https://www.thingiverse.com/thing:3025584 as the base. But without the loop and with tighter tolerance for the alignment clip, so it can friction hold the alignment pin.

This is a work in progress, I will print this out soon to confirm if it works well as a retaining clip.

V1 :- Works well with PETG filament. PLA is a bit too soft.

Tagi