Factory Part Cooling Fan Duct For Anet A8
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a factory style duct for my new Anet A8 printer because the printed duct that came with my printer had a…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 135
- Wydruki
- 0
- Wyświetlenia
- 329
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted a factory style duct for my new Anet A8 printer because the printed duct that came with my printer had a pretty good sized hole in the left side of it. I tried several models of ducts I found here on Thingiverse, but it would appear that my part cooling fan has a larger opening than any of the models I found here, because none of them fit. That said, This model that I made from measurements of the defective duct that came with my printer, may won't fit yours.
The outer measurements for the top part of the duct my printer came with is 17.3mm x 13.8mm. If your duct doesn't measure similar, don't waste your time with this model.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
100%
Filament: Generic PLA White
Category: 3D Printer Parts