Pegboard holder for Sharpie pens

Holder for three 11mm diameter Sharpie pens. Will work with anything with a diameter of about 12.8mm or lower. 

Designed for US sourced 1/8" thick MDF pegboard with ¼" holes on 1" centers. Might work with other types of pegboard but I don't have that so I can't test it.

Printing instructions

Can print at whatever layer height in whatever material you think makes sense. If you want supports, you can do that, but I've printed the top pins unsupported and they've only required a little cleanup after the fact. Doesn't have to be high infill or shell count, Sharpies aren't exactly heavy so they won't be putting much stress on it. 

Original description

This is from when I originally published this model on thingi-dumpster-fire-verse back in 2018. Not all the statements in here are still accurate.

I find I often need Sharpies (small permanent markers) while working on bikes, and previously have kept my Sharpies in a pair of hooks, which was always pretty tenative, the markers would always fall off, so I've wanted to make a proper holder for a while, and I'm still getting familiar with Fusion 360, so this was a perfect application. While this works well for holding Sharpies, it could also be used for many other objects with about the same dimensions.

I was going to start with my pegboard 2 position blank - but realized that this was an opportunity to redo it from scratch and make it a fully parameterized model, especially since the original design didn't quite fit all the pegboards that I used, so I wanted to be able to fine-tune the dimensions.

I also sized the holes a bit large for the Sharpie body, as the silver Sharpie works best when it's stored inverted, so I sized all the holes for that. Of course, since it's parameterized, if you wanted to change the diameters, you could do that.