EDC Screwdriver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organise your pockets with an EDC Screwdriver. Accepts standard 1/4" hex driver bits.
- Ocena
- 4,714 / 5
- Polubienia
- 283
- Pobrania
- 1006
- Wydruki
- 9
- Wyświetlenia
- 7511
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Organise your pockets with an EDC Screwdriver.
Accepts standard 1/4" hex driver bits.
Hex bit can be inserted in end like a typical screwdriver or in the side for additional torque.
2x1/4" hex bits are magnetically retained in the shaft of the screwdriver
Print instructions
Screwdriver is designed to be printed flat on the print bed.
3mf file has a pause in the gcode at 5.15mm to insert the magnets (though wasn't working properly for me - only came up with the pause message briefly and continued to print so might be best to change this to a colour swap to pause it properly - I'm sure it was all user error though :) )
Magnets will need to be press fit it to the shaft while paused (4th pic kinda shows the outline thy are located before being sealed in - sorry didn't get a pic of this on the print bed)
I found the best way to press fit the magnets is to use a screwdriver with a hexbit (see pic 5) and attach the magnet to the end.
Requires - 8x 5mmx2mm neodymium magnets (picked up 20 for about $3 on eBay)