EDC Screwdriver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Organise your pockets with an EDC Screwdriver. Accepts standard 1/4" hex driver bits.
- Rating
- 4.714 / 5
- Likes
- 283
- Downloads
- 1,006
- Makes
- 9
- Views
- 7,511
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
Organise your pockets with an EDC Screwdriver.
Accepts standard 1/4" hex driver bits.
Hex bit can be inserted in end like a typical screwdriver or in the side for additional torque.
2x1/4" hex bits are magnetically retained in the shaft of the screwdriver
Print instructions
Screwdriver is designed to be printed flat on the print bed.
3mf file has a pause in the gcode at 5.15mm to insert the magnets (though wasn't working properly for me - only came up with the pause message briefly and continued to print so might be best to change this to a colour swap to pause it properly - I'm sure it was all user error though :) )
Magnets will need to be press fit it to the shaft while paused (4th pic kinda shows the outline thy are located before being sealed in - sorry didn't get a pic of this on the print bed)
I found the best way to press fit the magnets is to use a screwdriver with a hexbit (see pic 5) and attach the magnet to the end.
Requires - 8x 5mmx2mm neodymium magnets (picked up 20 for about $3 on eBay)