Fysetc Spider with stacked Mellow Fly 5160 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A DIN rail bracket for a Fystec Spider with the option to add a layer for two Mellow Fly 5160 Pro stepper driver
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 888
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
A DIN rail bracket for the Fysetc Spider controller with the possibility of adding a layer for two Fly Mellow 5160 pro stepper driver and fans.
Each layer can use either m3 nuts or screws (see photos).
No supports needed for printing.
Requirements:
This bracket uses the two of the Voron DIN rail clips from: https://github.com/VoronDesign/Voron-2/blob/Voron2.4/STLs/Electronics_Bay/pcb_din_clip_x3.stl
It is possible to use more than 2 clips, but if the outermost clip positions are used, there is no space left to properly tighten the screws.
Hardware:
For each DIN rail clip 2x m2x10mm self-tapping countersunk screws are required.
If you just want to use the Fysetc Spider bracket you will need:
- 4x m3x8mm screws and 4x m3 nuts
For the complete setup following is required:
- Fysetc Spider bracket: 4x m3x10mm screws and 4x30mm standoffs
- 5160 pro bracket: 4x m3x10mm screws to mount it to the Spider bracket and 8x m3x10mm screws, 8x m3 nuts and 8x25mm standoffs for the fan brackets
- For each fan bracket: 4x m3x10mm countersunk screws and 4x screws according to the fans you use